Climberbot III

vlcsnap-2013-10-01-19h13m20s116

A little one is born. After a lot of 3D refinement there is a working prototype on the road… keep reading!

Finally the third prototype generation of Climberbot is working. This time we made the whole design and 3D printed the parts. It includes the board mentiones in the previous post, that interconnects a microcontroller board, a motor driver carrier board and an accelerometer.

IMG_20130925_181313_1024 IMG_20130928_104359_1024 IMG_20130928_104610_1024

The traks are also 3D printed, inspired in this thing and this thing. To try adding some grip to the tracks we spreaded silicone rubber over them, but the goal is to cast them in rubber.

Finally some testing. It needs a lot of improvements, but it works!

Flattr this!

Leave a Reply

Your email address will not be published. Required fields are marked *